Dlp- G144 Enable Or Disable Otn Itu-T G.709 Performance Monitoring - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring
Step 2 Complete the
page 9-20
to enable or disable optical transport network (OTN) ITU-T G.709 monitoring.
Complete the
Step 3
needed for TXP_MR_10E and MXP_2.5G_10E cards to enable or disable OTN forward error correction
(FEC) monitoring.
Complete the following tasks as needed to view PM parameters:
Step 4
•
•
•
•
•
•
•
Note
Stop. You have completed this procedure.
DLP-G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the card you want to monitor. The card view appears.
Step 1
Determine if the port where you want to enable or disable OTN ITU-T G.709 is in service (IS). (Click
Step 2
the Provisioning > Line tabs, and observe the Service State column for that port.) If it is IS, perform the
following tasks for that port. If not, go to
a.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
9-20
"DLP-G144 Enable or Disable OTN ITU-T G.709 Performance Monitoring" task on
as needed for any TXP or MXP card (except the TXP_MR_10E and MXP_2.5G_10E cards)
"DLP-G145 Enable or Disable OTN FEC Performance Monitoring" task on page 9-21
DLP-G146 View Optics PM Parameters, page 9-22
DLP-G147 View Payload PM Parameters, page 9-23
DLP-G148 View OTN PM Parameters, page 9-25
DLP-G149 View Payload Statistics PM Parameters, page 9-27
DLP-G150 View Payload Utilization PM Parameters, page 9-28
DLP-G151 View Payload History PM Parameters, page 9-30
DLP-G152 View Payload SONET PM Parameters, page 9-31
To refresh, reset, or clear PM counts, see the
page 9-2.
DLP-G108 Change the Service State for a Port, page 7-18
(OOS,DSBLD).
"NTP-G73 Change the PM Display" procedure on
This task enables or disables OTN ITU-T G.709 monitoring of near-end
or far-end performance on a card and port during selected time intervals
to detect possible problems. This task can be performed for any TXP or
MXP card except the TXP_MR_10E and MXP_2.5G_10E cards. See the
"DLP-G145 Enable or Disable OTN FEC Performance Monitoring" task
on page 9-21 for TXP_MR_10E and MXP_2.5G_10E card information.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Step 3.
Chapter 9 Monitor Performance
to set the port to Out of Service, Disabled
as
September 2005