Dlp- G313 Verify Osc-Csm Transmit Power - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
Step 7 Display the OSC-CSM or OSCM in card view.
Click the Maintenance > ALS tabs.
Step 8
From the ALS Mode drop-down list, choose AutoRestart. Click Apply.
Step 9
If a second OSC-CSM or OSCM card is installed, repeat Steps
Step 10
Stop. You have completed this procedure.
DLP-G313 Verify OSC-CSM Transmit Power
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Throughout this task, west refers to Slots 1 through 8, and east refers to Slots 10 through 17.
Note
Display the OSC-CSM card in card view.
Step 1
Click the Provisioning > Optical Line > Parameters tabs.
Step 2
Locate the Power parameter for Port 7, then record the value: _______. If an OPT-PRE card is installed
Step 3
in the same side of the shelf as the OSC-CSM, continue with
Change to node view, then click the Provisioning > WDM-ANS tabs.
Step 4
Record the amplifier working mode value from one of the following:
Step 5
For OSC-CSM cards installed on the east side:
a.
b.
c.
d.
For OSC-CSM cards installed on the west side:
a.
b.
c.
d.
September 2005
This procedure verifies the transmit power of the OSC-CSM card.
None
"DLP-G46 Log into CTC" task on page 2-25
Required
Onsite or remote
Superuser
In the Selector window on the left, expand the East Side parameters tree view.
Expand the RX category.
Expand the Amplifier category, then highlight Working Mode.
Record the EastSide.Rx.Amplifier.Working Mode parameter displayed in the right pane.
In the Selector window on the left, expand the West Side parameters tree view.
Expand the RX category.
Expand the Amplifier category, then highlight Working Mode.
Record the WestSide.Rx.Amplifier.Working Mode parameter displayed in the right pane.
6
Step
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
DLP-G313 Verify OSC-CSM Transmit Power
through 9 on the second card.
4. If not, continue with Step 7.
3-87