Ntp- G61 Modify And Delete Overhead Circuits - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 7 Create Channels and Circuits
Step 8 Click Finish.
Return to your originating procedure (NTP).
Step 9
NTP-G61 Modify and Delete Overhead Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Deleting circuits can be service affecting and should be performed during a maintenance window.
Caution
Complete the
Step 1
to repair or delete a circuit. If you are already logged in, continue with Step 2.
As needed, complete the
Step 2
As needed, complete the
Step 3
Stop. You have completed this procedure.
DLP-G111 Repair an IP Tunnel
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Obtain the original IP address of the node in question.
Step 1
Step 2 From the View menu, choose Go to Network View.
Step 3 From the Tools menu, choose Overhead Circuits > Repair IP Circuits.
Review the text in the IP Repair wizard and click Next.
Step 4
In the Node IP address area, complete the following:
Step 5
•
September 2005
This procedure repairs IP circuits and deletes overhead circuits.
None
NTP-G60 Create Overhead Circuits, page 7-13
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"DLP-G111 Repair an IP Tunnel" task on page
"DLP-G112 Delete Overhead Circuits" task on page
This task repairs circuits that have a PARTIAL status as a result of node
IP address changes.
None
DLP-G107 Create an IP-Encapsulated Tunnel, page 7-17
As needed
Onsite or remote
Provisioning or higher
Node—Choose the node that has a PARTIAL circuit.
NTP-G61 Modify and Delete Overhead Circuits
for a node on the network where you want
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
7-21.
7-22.
7-21