Cisco ONS 15454 DWDM Installation And Operation Manual page 375

Chapter 5 Provision Transponder and Muxponder Cards
Step 7 Click the Provisioning > Line > Section Trace tabs.
Modify any of the settings described in
Step 8
Table 5-18
Parameter
Port
Trace Mode
Section Trace
String Size
Transmit
Expected
Received
Step 9 Click Apply.
Return to your originating procedure (NTP).
Step 10
September 2005
DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Table
TXP_MR_10G and MXP_MR_10E Card Section Trace Settings
Description
Sets the port number.
Sets the trace mode.
Sets the trace string size. Select either
radio button.
Displays the current transmit string; sets
a new transmit string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
Displays the current expected string; sets
a new expected string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
(Display only) Displays the current
received string. You can click Refresh to
manually refresh this display, or check
the Auto-refresh every 5 sec check box to
keep this field updated.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-18.
Options
1
•
2
•
3
•
4
•
Off/None
•
Manual
•
1 byte
•
• 16 byte
String of trace string size
String of trace string size
String of trace string size
5-37