Dlp- G35 Inspect The Shelf Installation And Connections - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 1 Install the Shelf and Common Control Cards
Table 1-13
Description
NTP-G8 Install the Fan-Tray Assembly, page 1-40
NTP-G9 Install the Alarm Expansion Panel (ANSI Only), page 1-44
NTP-G10 Attach Wires to Alarm, Timing, LAN, and Craft Pin Connections, page
1-47
NTP-G11 Install an External Wire-Wrap Panel on the AEP (ANSI Only), page 1-58
NTP-G13 Install the Rear Cover (ANSI Only), page 1-64
NTP-G14 Install DWDM Equipment, page 1-66
NTP-G15 Install the Common Control Cards, page 1-71
Complete the
Step 3
Complete the
Step 4
Continue with
Step 5
Stop. You have completed this procedure.
DLP-G35 Inspect the Shelf Installation and Connections
Purpose
Tools/Equipment
Prerequisite Procedures None
Required/As Needed
Onsite/Remote
Security Level
Make sure all external wiring connections on the backplane (i.e. power, ground, alarms, etc.) are secure.
Step 1
If a wire or cable is loose, return to the appropriate procedure in this chapter to correct it.
(ETSI only) To check that the FMEC cover is seated correctly, verify that it can be easily closed without
Step 2
disturbing cables.
Return to your originating procedure (NTP).
Step 3
August 2005
ONS 15454 ANSI Shelf Installation Task Summary (continued)
"DLP-G35 Inspect the Shelf Installation and Connections" task on page
"DLP-G36 Measure Voltage" task on page
Chapter 2, "Connect the PC and Log into the GUI."
Use this task to inspect the shelf installation and connections and verify that
everything is installed and connected properly.
None
Required
Onsite
None
DLP-G35 Inspect the Shelf Installation and Connections
1-78.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Completed
1-77.
1-77