Figure 3-6 Nodes Behind A Firewall; Ntp- G27 Set Up The Ons 15454 For Firewall Access - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
NTP-G27 Set Up the ONS 15454 for Firewall Access
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Log into a node that is behind the firewall. See the
Step 1
instructions. If you are already logged in, continue with Step 2.
Complete the
Step 2
Figure 3-6
network. For the computer to access the ONS 15454 nodes, you must provision the IIOP listener port
specified by your firewall administrator on the ONS 15454.
Figure 3-6
CTC computer
If the CTC computer resides behind a firewall, complete the
Step 3
on the CTC Computer" task on page
Figure 3-7
ONS 15454, you must provision the IIOP port on the CTC computer and on the ONS 15454.
September 2005
This procedure provisions ONS 15454 nodes and CTC computers for
access through firewalls.
IIOP listener port number provided by your LAN or firewall administrator
NTP-G22 Verify Common Card Installation, page 3-4
As needed
Onsite or remote
Provisioning or higher
"DLP-G61 Provision the IIOP Listener Port on the ONS 15454" task on page
shows ONS 15454 nodes in a protected network and the CTC computer in an external
Nodes Behind a Firewall
Firewall
Unprotected
network
External network
shows a CTC computer and ONS 15454 behind firewalls. For the computer to access the
NTP-G27 Set Up the ONS 15454 for Firewall Access
"DLP-G46 Log into CTC" task on page 2-25
Private
network
Port
filtering
Protected network
"DLP-G62 Provision the IIOP Listener Port
3-25.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
IIOP port
ONS 15454
IIOP port
ONS 15454
for
3-24.
3-23