Ntp- G131 Convert Dwdm Nodes To Hybrid Nodes - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G131 Convert DWDM Nodes to Hybrid Nodes
Step 3 Click Retrieve Last Activity Time to display the most recent activity date and time for users in the
Last Activity Time field.
Return to your originating procedure (NTP).
Step 4
NTP-G131 Convert DWDM Nodes to Hybrid Nodes
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You cannot perform this upgrade on software released prior to Software Release 4.6.
Note
Downgrade procedures from OSC-CSM cards to OSCM cards are not supported. Contact the
Note
Cisco Technical Assistance Center (TAC) for more information. See the
Assistance" section on page
Complete the
Step 1
upgrade. If you are already logged in, continue with Step 2.
Step 2 Complete the
If you have timing set up on the OSCM card, delete the timing source:
Step 3
a.
b.
c.
d.
If you have overhead circuits on the node, complete the
Step 4
page
Delete the DWDM ring ID:
Step 5
a.
b.
c.
If you have OSC terminations, refer to the
Step 6
to delete the OSC termination.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-58
lxxvi.
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
In node view, click the Provisioning > Timing tabs.
Scroll to the Reference Lists area.
In the NE Reference column, select Internal Clock from the drop-down list for all entries where the
selected Clock Source is the OSCM that you are removing.
Click Apply.
7-22.
In node view, click the Provisioning > Comm Channels > OSC tabs.
Select the DWDM Ring ID that you want to delete and click Delete.
In the Delete DWDM Ring ID confirmation box, click Yes. Confirm that the changes appear.
This procedure upgrades an OSCM card to an OSC-CSM card. OSCM
cards use Slots 8 and 10, which are required for cross-connect cards in
TDM and DWDM hybrid configurations. The OSC-CSM cards can be
installed in Slots 1 to 6 or 12 to 17.
Two OSC-CSM cards
None
As needed
Onsite
Maintenance or higher
"DLP-G186 Delete an OSC Termination" task on page 10-41
Chapter 10
"Obtaining Technical
at the node where you will perform the
13-2.
"DLP-G112 Delete Overhead Circuits" task on
Manage the Node
September 2005