Cisco ONS 15454 DWDM Installation And Operation Manual page 366

DLP-G221 Change OTN Settings for TXP_MR_10G and TXP_MR_10E Cards
Table 5-12
Parameter
SD BER
Asynch/Synch
Mapping
Table 5-13
Table 5-13
Parameter
Port
ES
SES
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-28
TXP_MR_10G and TXP_MR_10E Transponder Card OTN Lines Settings (continued)
Description
Sets the signal degrade bit error rate.
(TXP_MR_10E only) The card can
perform multiplexing per ITU-T G.709.
The ODUk (client SONET/SDH payload)
can be mapped to the Optical Channel
(OTUk) either asynchronously or
synchronously with this setting.
describes the values on the Provisioning > OTN > G.709 Thresholds tab.
TXP_MR_10G and TXP_MR_10E Transponder Card ITU-T G.709 Threshold Settings
Description
(Display only) Port number.
Severely errored seconds. Two types of
thresholds can be asserted. Selecting the
SM (OTUk) radio button selects FEC,
overhead management, and PM using
OTUk. Selecting the PM radio button
selects path PM using ODUk.
Severely errored seconds
Chapter 5 Provision Transponder and Muxponder Cards
Options
• 1E-5
• 1E-6
1E-7
•
1E-8
•
1E-9
•
Asynch mapping
•
Synch mapping
•
Options
2
Numeric. Threshold display options
include:
Direction—Near End or Far End
•
Interval—15 Min (minutes) or 1 day
•
Types—SM (OTUk) or PM (ODUk)
•
Choose an option in each category and
click Refresh.
SM (OTUk) is the ITU-T G.709
Note
optical channel transport unit
order of k overhead frame used
for management and performance
monitoring. PM (ODUk) is the
ITU-T G.709 optical channel data
unit order of k overhead frame
unit used for path performance
monitoring.
Numeric. Threshold display options
include:
Direction—Near End or Far End
•
Interval—15 Min (minutes) or 1 day
•
Types—SM (OTUk) or PM (ODUk)
•
Choose an option in each category and
click Refresh.
September 2005