Dlp- G302 Provision The Txp_Mr_10G And Txp_Mr_10E Client Port Alarm And Tca Thresholds - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
Table 5-9
Card
TXP_MR_10G
TXP_MR_10E
Step 8 Return to your originating procedure (NTP).
DLP-G302 Provision the TXP_MR_10G and TXP_MR_10E Client Port Alarm and
TCA Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the TXP_MR_10G or TXP_MR_10E card where you want to change the
Step 1
client port alarm and TCA settings.
Click the Provisioning > Optics Thresholds tabs. The TCA thresholds are shown by default.
Step 2
Referring to
Step 3
Low, TX Power High, and TX Power Low based on the client interface at the other end. For additional
information about client SFP and XFP interfaces, also known as PPMs, refer to
Specifications."
Note
Note
Click Apply.
Step 4
September 2005
DLP-G302 Provision the TXP_MR_10G and TXP_MR_10E Client Port Alarm and TCA Thresholds
TXP_MR_10G and TXP_MR_10E Trunk Port Alarm Thresholds
Alarm RX Alarm RX
Power Low Power High
–24 dBm –8 dBm
–20 dBm –8 dBm
This task provisions the client port alarm and TCA thresholds for the
TXP_MR_10G and TXP_MR_10E cards.
None
DLP-G278 Provision the Optical Line Rate, page 5-6
DLP-G46 Log into CTC, page 2-25
Required
Onsite or remote
Provisioning or higher
Table 5-10, provision the Port 1 (Client) TCA thresholds for RX Power High, RX Power
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
Do not modify the Laser Bias parameters.
Alarm TX Alarm TX
Power Low Power High
2 dBm 4 dBm
3 dBm 7 dBm
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Appendix B, "Hardware
5-25