Table A-2 Description Of Node Icons On Network View Map - Cisco ONS 15454 DWDM Installation And Operation Manual

Appendix A CTC Information and Shortcuts
Table A-2
Node Name
SONET
SDH
Hybrid OADM
Hybrid line amplifier
Hybrid terminal
Passive hybrid terminal
Amplified TDM
Hub
OADM
ROADM
August 2005
Description of Node Icons on Network View Map
Icon Description
A SONET, SDH, hybrid, or amplified time-division
multiplexing (TDM) node icon is represented as a cylinder
with crossed arrows.
•
•
•
•
•
•
A DWDM hub node icon is represented as a three-dimensional
cylinder with amplifiers. A hub node contains at least two
32DMX or 32DMX-O cards and two 32MUX-O. No OADM
cards are provisioned.
A DWDM OADM node icon is represented as a
three-dimensional cylinder with arrows. An OADM node
contains at least one AD-xC-xx.x or one AD-xB-xx.x. No
32MUX-O, 32DMX-O, or 32DMX cards are provisioned.
A reconfigurable OADM (ROADM) node icon is represented
as a three-dimensional cylinder with two amplifier symbols
that have arrows between them. An ROADM node contains at
least one 32-channel Wavelength Selective Switch (32WSS).
A single-slot 32DMX or double-slot 32DMX-O can be
installed, but is not required. Transponders (TXPs) and
muxponders (MXPs) can be installed in Slots 6 and 12. If
amplification is not used, TXPs or MXPs can be installed in
Slots 1 and 17. If OPT-BSTs are not installed, Optical Service
Channel and Combiner/Separator Module (OSC-CSM) cards
are installed in Slots 2 and 16 and Slots 8 and 10 are empty.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
A.1.1 Node Icons on the Network View Map
A SONET or SDH node can include OC-N cards,
electrical cards, cross-connects, Storage Access
Management (SAM) cards, and Ethernet cards.
A hybrid optical add/drop multiplexing (OADM) node
contains at least one Channel OADM (AD-xC-xx.x) or
one Band OADM (AD-xB-xx.x) card and two Advanced
Timing, Communications, and Controller (TCC2/TCC2P)
cards. TDM cards can be installed in any available slot.
A hybrid line amplifier node contains amplifiers and both
TDM and dense wavelength division multiplexing
(DWDM) cards.
A hybrid terminal node contains at least one 32-Channel
Multiplexer (32MUX-O) card, one Double-Slot
32-Channel Demultiplexer (32DMX-O) card, amplifiers,
two TCC2/TCC2P cards, and TDM cards.
A passive hybrid terminal node has the same equipment as
the hybrid terminal node, but does not contain amplifiers.
An amplified TDM node is a node that increases the span
length between two ONS 15454 nodes that contain TDM
cards and optical amplifiers. Amplified TDM nodes
contain either Optical Booster (OPT-BST) amplifiers or
AD-1C cards.
A-3