Ntp- G57 Create A Logical Network Map - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 6 Turn Up Network
b.
Confirm that the client or test set at the local site is operating normally with no alarms. If the test set is
Step 18
reporting active alarms, contact your next level of support.
Note
From the Switch Commands area below the Selected Group area, click Clear, then click YES to return
Step 19
the protection group to the original state.
Repeat Steps
Step 20
Stop. You have completed this procedure.
NTP-G57 Create a Logical Network Map
Purpose
Tools
Prerequisite Procedures This procedure assumes that network turn-up is complete.
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
create the network map. If you are already logged in, continue with Step 2.
From the View menu, choose Go to Network View.
Step 2
Step 3 Change the position of the nodes in the network view according to your site plan.
a.
b.
Step 4 On the network view map, right-click and choose Save Node Position from the shortcut menu.
Click Yes in the Save Node Position dialog box.
Step 5
CTC opens a progress bar and saves the new node positions.
September 2005
For the Standby transponder slot LEDs:
DWDM Port is green.
–
Client Port is not illuminated.
–
It is normal to see a traffic hit on the test set during a protection switch.
5 through 19 for each protection group at your site.
This procedure allows a Superuser to create a consistent network view for
all nodes on the network.
None
As needed
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page 2-25
Click a node to select it, then press the Ctrl key while you drag and drop the node icon to a new
location.
Repeat Step a for each node you need to position.
at a node on the network where you want to
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G57 Create a Logical Network Map
6-15