Dlp- G69 Install Fiber-Optic Cables For An Osc Regeneration Node - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G69 Install Fiber-Optic Cables for an OSC Regeneration Node
Step 2 Plug one end of the fiber cable into the desired RX port.
Route the fiber cable on the card faceplate through the fiber clip on the faceplate, if provided. (Fiber clips
Step 3
are factory-attached to the faceplates of OSCM, OPT-PRE, and OPT-BST cards.)
Step 4 Route the fiber cable through the cable-routing channel and cutout on the appropriate side of the shelf
assembly, as necessary
As needed, route slack fiber-optic cable around the round cable retainers in the fiber-storage tray
Step 5
(Figure 15-38 on page
When you close the fiber-storage tray, the cables must not be pinched, and the cable bend radius must
Caution
be equal to or greater than the minimum radius that is recommended in your site specifications. As you
route each cable through the fiber-storage tray, make sure that adequate cable slack remains.
Step 6 Route the fiber cable out either side of the fiber-storage tray as necessary.
Step 7 Plug the other end of the cable into the desired TX port.
Note
Step 8 Repeat
Step 9 Return to your originating procedure (NTP).
DLP-G69 Install Fiber-Optic Cables for an OSC Regeneration Node
Purpose
Tools
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Throughout this task, west refers to Slots 1 through 8, and east refers to Slots 10 through 17.
Note
Refer to the Cisco MetroPlanner Internal Connections table (see
Step 1
when completing connections. Before you begin OSC regeneration node connections, read the following
rules:
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-60
(Figure 15-35 on page
15-40).
Cards display an SF LED after the OSC terminations are created (see the
OSC Terminations" procedure on page
correctly. For example, an RX port is connected to another RX port or a TX port is connected to
another TX port.
2 through 7 until you have connected the nodes according to the site plan.
This task installs fiber-optic cables on an OSC regeneration node in a
DWDM shelf.
Fiber-optic cables
NTP-G115 Clean Fiber Connectors, page 13-25
NTP-G139 Verify Cisco MetroPlanner Reports and Files, page 3-3
As needed
Onsite
None
The west OSC-CSM COM TX port connects to the east OSC-CSM COM RX port.
The west OSC-CSM COM RX port connects to the east OSC-CSM COM TX port.
15-37).
3-84) if transmit and receive fibers are not connected
Table 3-1 on page
Chapter 3 Turn Up a Node
"NTP-G38 Provision
3-3) for your site
September 2005