Switching Commands - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G84 Initiate and Clear Y-Cable and Splitter External Switching Commands
Step 4 Click Yes in the Delete Protection Group dialog box. Confirm that the changes appear.
Return to your originating procedure (NTP).
Step 5
NTP-G84 Initiate and Clear Y-Cable and Splitter External

Switching Commands

Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Splitter protection groups are automatically created when you install a TXPP_MR_2.5G or
Note
MXPP_MR_2.5G card.
Complete the
Step 1
Step 2.
Step 2 To perform a Manual protection switch, complete the
Protection Switch" task on page
To perform a Force protection switch, complete the
Step 3
Protection Switch" task on page
To clear a Force or Manual protection switch, complete the
Step 4
Y-Cable or Splitter Protection Switch" task on page
To prevent traffic on a working or protect card from switching to the other card in the pair, complete the
Step 5
"DLP-G181 Apply a Lock-On" task on page
Step 6 To prevent traffic from switching to the protect card, complete the
on page
To remove a lock-on or lockout and return a protection group to its usual switching method, complete
Step 7
the
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-34
"DLP-G46 Log into CTC" task on page
10-37.
"DLP-G183 Clear a Lock-On or Lockout" task on page
This procedure describes how to apply and remove Manual and Force
protection switches on Y-cable and splitter protection groups. It also
describes how to apply and remove a Lock On or Lock Out protection
command to a Y-cable protection group.
None
NTP-G32 Install the Transponder and Muxponder Cards, page 3-43
NTP-G33 Create a Y-Cable Protection Group, page 5-10
As needed
Onsite
Superuser
2-25. If you are already logged in, continue with
"DLP-G178 Apply a Manual Y-Cable or Splitter
10-35.
"DLP-G179 Apply a Force Y-Cable or Splitter
10-35.
10-36.
10-37.
Chapter 10
"DLP-G180 Clear a Manual or Force
"DLP-G182 Apply a Lockout" task
10-38.
Manage the Node
September 2005