Ntp- G93 Modify The 32Wss Thresholds And Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 11 Change DWDM Card Settings
NTP-G93 Modify the 32WSS Thresholds and Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
32WSS card settings. If you are already logged in, continue with Step 2.
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
DLP-G212 Change Optical Channel Parameters for the 32WSS Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the 32WSS card where you want to change the optical channel parameter
Step 1
settings.
Click the Provisioning > Optical Chn: Optical Connector tab for one of the four available groups of
Step 2
eight optical channels.
September 2005
This procedure changes the 32WSS card thresholds and settings.
None
NTP-G30 Install the DWDM Cards, page 3-39
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page
DLP-G212 Change Optical Channel Parameters for the 32WSS Card, page 11-33
DLP-G213 Change the 32WSS Optical Channel Thresholds, page 11-36
To use the alarm profile tab, including creating alarm profiles and suppressing alarms, see
Note
Chapter 8, "Manage Alarms."
DLP-G214 Change Optical Line Parameters for the 32WSS Card, page 11-39
DLP-G215 Change the 32WSS Card Optical Line Thresholds, page 11-40
"NTP-G103 Back Up the Database" procedure on page
This task changes the optical channel parameter settings for the 32WSS
card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
NTP-G93 Modify the 32WSS Thresholds and Settings
at the node where you want to change the
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-2.
13-2.
11-33