Dlp- G127 Modify Alarm, Condition, And History Filtering Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G127 Modify Alarm, Condition, and History Filtering Parameters
Alarm filtering is enabled in the card, node, and network views of the same window for all nodes in the
network. For example, if the Filter tool is enabled in the node view Alarms window, the network view
Alarms window and card view Alarms window also show the tool enabled.
If you want alarm filtering enabled when you view conditions, repeat Steps
Step 3
window.
If you want alarm filtering enabled when you view alarm history, repeat Steps
Step 4
window.
Step 5 Return to your originating procedure (NTP).
DLP-G127 Modify Alarm, Condition, and History Filtering Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
At node, network, or card view, click the Alarms tab, Conditions tab, or History tab.
Step 1
Click the Filter button on the left side of the bottom toolbar.
Step 2
The filter dialog box appears, displaying the General tab.
the Conditions and History tabs have similar dialog boxes.
Figure 8-8
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
8-26
This task changes alarm and condition reporting in all network nodes.
None
DLP-G126 Enable Alarm Filtering, page 8-25
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Alarm Filter Dialog Box General Tab
Chapter 8
1 and 2 using the Conditions
1 and
Figure 8-8 shows the Alarm Filter dialog box;
Manage Alarms
2 using the History
September 2005