Cisco ONS 15454 DWDM Installation And Operation Manual page 1025

Appendix A CTC Information and Shortcuts
Table A-3 CTC Menu and Toolbar Options (continued)
Menu Menu Option
Tools Circuits
Overhead Circuits
Topology Upgrade
Manage VLANs
Open TL1
Connection
Open IOS
Connection
Help Contents and Index
User Manuals
About CTC
August 2005
Toolbar Description
— Displays the following options:
• Repair Circuits—Repairs incomplete circuits following replacement of the
ONS 15454 alarm interface panel (AIP). Refer to the Cisco ONS 15454
SONET and DWDM Troubleshooting Guide or the Cisco ONS 15454 SDH
Troubleshooting Guide for more information.
Reconfigure Circuits—Allows you to reconfigure circuits. Not applicable to
•
DWDM nodes.
Set Path Selector Attributes—Allows you to edit path protection or
•
subnetwork connection protection (SNCP) circuit path selector attributes.
Not applicable on DWDM nodes.
Set Circuit State—Allows you to change a circuit state. Not applicable on
•
DWDM nodes.
Roll Circuit—Allows you to reroute live traffic without interrupting service.
•
• Delete Rolls —Removes rolls that are not deleted by CTC after a roll has
been completed.
— Displays the Repair IP Tunnels option, which fixes circuits that are in the
PARTIAL status as a result of node IP address changes. See the
Repair an IP Tunnel" task on page
— Displays the following options:
• Convert path protection (or SNCP) to BLSR (or MS-SPRing)—Converts a
path protection to a bidirectional line switch ring (BLSR). Not applicable to
DWDM nodes.
Convert Unprotected to path protection (or SNCP)—Converts a
•
point-to-point or linear add/drop multiplexer (ADM) to path protection. Not
applicable to DWDM nodes.
— Displays a list of VLANs that have been created and allows you to delete
VLANs. Not applicable to DWDM nodes.
Displays the TL1 session dialog box so you can create a TL1 session to a
specific node. Refer to the Cisco ONS SONET TL1 Reference Guide and the
Cisco ONS 15454 SDH TL1 Reference Guide.
Displays the Cisco IOS command line interface dialog box if a Cisco IOS
capable card (ML1000-2, ML100T-12, or ML-100X-8) is installed in the node.
Not applicable to DWDM nodes.
— Displays the online help window.
— Displays the Cisco ONS 15454 documentation.
— Displays the software version and the nodes in the CTC session.
7-21.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
A.2.1 CTC Menu and Toolbar Options
"DLP-G111
A-7