Dlp- G157 Disable Automatic Power Control - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G157 Disable Automatic Power Control
DLP-G157 Disable Automatic Power Control
Purpose
Tools/Equipment
Prerequisite Procedures All procedures in the following chapters:
Required/As Needed
Onsite/Remote
Security Level
Disable APC only to perform specific troubleshooting or node provisioning tasks. Always enable APC
Caution
as soon as the tasks are completed. Leaving APC disabled can cause traffic loss.
In node view, click the Maintenance > DWDM > APC tabs.
Step 1
Click Disable APC.
Step 2
Verify that the Enable APC button changes to Disable APC.
Step 3
Return to your originating procedure (NTP).
Step 4
DLP-G158 Enable Automatic Power Control
Purpose
Tools/Equipment
Prerequisite Procedures All procedures in the following chapters:
Required/As Needed
Onsite/Remote
Security Level
Disable APC only to perform specific troubleshooting or node provisioning tasks. Always enable APC
Caution
as soon as the tasks are completed. Leaving APC disabled can cause traffic loss.
In node view, click the Maintenance > DWDM > APC tabs.
Step 1
Click Enable APC.
Step 2
In the confirmation dialog box, Click Yes.
Step 3
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-4
This task disables the DWDM APC.
None
Chapter 3, "Turn Up a Node"
Chapter 6, "Turn Up Network"
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser
This task enables the DWDM APC.
None
Chapter 3, "Turn Up a Node"
Chapter 6, "Turn Up Network"
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Superuser
Chapter 10 Manage the Node
September 2005