Table 5-27 Mxp_2.5G_10G And Mxp_2.5G_10E Muxponder Card Fec Threshold Settings; Table 5-28 Mxp_2.5G_10G And Mxp_2.5G_10E Muxponder Card Trail Trace Identifier - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Table 5-26
Parameter
BBE
FC
Table 5-27
Table 5-27
Parameter
Port
Bit Errors
Corrected
Uncorrectable
Words
Table 5-28
Table 5-28
Parameter
Port
Level
Trace Mode
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-46
MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card ITU-T G.709 Threshold Settings
Description
Background block errors
Failure counter
describes the values on the Provisioning > OTN > FEC Thresholds tab.
MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card FEC Threshold Settings
Description
(Display only) Displays the port number. 5
Displays the number of bit errors
corrected during the interval selected.
The interval can be set for 15 minutes or
one day.
Displays the number of uncorrectable
words during the interval selected. The
interval can be set for 15 minutes or one
day.
describes the values on the Provisioning > OTN > Trail Trace Identifier tab.
MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card Trail Trace Identifier
Settings
Description
Sets the port number. The trail trace
identifier is applicable only to the trunk
interface, which handles ITU-T G.709
frames.
Sets the level.
Sets the trace mode.
Chapter 5 Provision Transponder and Muxponder Cards
Options
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
a bullet and click Refresh.
Numeric. Can be set for Near End or Far
End, for 15-minute or one-day intervals,
or for SM (OTUk) or PM (ODUk). Select
a bullet and click Refresh.
Options
Numeric
Numeric
Options
5
•
• Section
Path
•
Off/None
•
Manual
•
September 2005