Dlp- G259 Manual Or Force Switch The Node Timing Reference - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G259 Manual or Force Switch the Node Timing Reference
Step 2 Complete the
needed.
Complete the
Step 3
page 13-19
Stop. You have completed this procedure.
DLP-G259 Manual or Force Switch the Node Timing Reference
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Timing > Source tabs.
Step 1
From the Reference drop-down list for the desired Clock, choose the desired reference.
Step 2
From the Operation drop-down list for the desired Clock, choose one of the following options:
Step 3
•
•
Click Apply next to the timing source.
Step 4
Click Yes in the confirmation dialog box. If the selected timing reference is an acceptable valid
Step 5
reference, the node switches to the selected timing reference. If the selected timing reference is invalid,
a warning dialog box appears. Click OK; the node will not switch to the new timing reference.
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-18
"DLP-G259 Manual or Force Switch the Node Timing Reference" task on page 13-18
"DLP-G260 Clear a Manual or Force Switch on a Node Timing Reference" task on
as needed.
Manual—This operation commands the node to switch to the reference you have selected if the
synchronization status message (SSM) quality of the reference is not lower than the current timing
reference.
Force—This operation commands the node to switch to the reference you have selected, regardless
of the SSM quality (if the reference is valid).
For information about the Clear option, see the
Note
on a Node Timing Reference" task on page
This task commands the node to switch to the timing reference you have
selected.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Maintenance or higher
13-19.
Chapter 13
"DLP-G260 Clear a Manual or Force Switch
Maintain the Node
as
September 2005