Dlp- G238 Change Oc-48/Stm-16 Settings For Mxp_Mr_2.5G And Mxpp_Mr_2.5G Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
Table 5-43
Parameter
Autoadjust
GFP Buffer
Threshold
GFP Buffers
Available
Click Apply.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-G238 Change OC-48/STM-16 Settings for MXP_MR_2.5G and
MXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
OC-48/STM-16 settings apply only to the trunk ports (Port 9 for the MXP_MR_2.5G card and Ports 9
Note
and 10 for the MXPP_MR_2.5G card.)
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
Step 1
OC-48/STM-64 settings.
Click the Provisioning > Line > SONET (ANSI) or SDH (ETSI). Tabs and parameter selections vary
Step 2
according to PPM provisioning.
Step 3 Modify any of the settings for the SONET or SDH tab as described in
September 2005
DLP-G238 Change OC-48/STM-16 Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line Distance Extension
Settings (continued)
Description
If checked, the threshold of the GFP
buffer between two MXP_MR_2.5G or
two MXPP_MR_2.5G cards is
automatically adjusted. This guarantees
the best utilization of the SONET/SDH
transport by balancing bandwidth and
latency.
If Autoadjust GFP Buffer Threshold is
not checked, sets the GFP buffer depth.
For shorter SONET transport distances,
Cisco recommends lower values to
decrease latency. For longer SONET
transport distances, Cisco recommends
higher values to provide higher
bandwidth.
This task changes the OC-48/STM-16 settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Options
Checked or unchecked
Numeric. Possible values are 16 through
1200 in multiples of 16.
Table 5-44.
5-71