Ntp- G75 Monitor Transponder And Muxponder Performance - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 9 Monitor Performance
Step 4 Click Refresh. Optical line power statistics for the selected port appear.
Click the Optical Band tab.
Step 5
In the Port drop-down list, choose an optical band port
Step 6
power statistics.
Table 9-4
Port Name
BAND RX
BAND TX
BAND RX
BAND TX
BAND RX
BAND TX
BAND RX
BAND TX
Click Refresh. Optical channel PM statistics for the selected port appear.
Step 7
Return to your originating procedure (NTP).
Step 8
NTP-G75 Monitor Transponder and Muxponder Performance
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
are already logged in, continue with
September 2005
Band OADM Optical Line Ports
Port Number
AD-1B-xx.x AD-4B-xx.x
1 1
2 2
— 3
— 4
— 5
— 6
— 7
— 8
This procedure enables you to view node near-end or far-end
performance during selected time intervals on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E) or
muxponder (MXP_2.5G_10E, MXP_MR_2.5G, MXPP_MR_2.5G,
MXP_2.5G_10G) card and port to detect possible performance problems.
None
Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see
and Circuits," Chapter 5, "Provision Transponder and Muxponder
Cards,"or
As needed
Onsite or remote
Retrieve or higher
"DLP-G46 Log into CTC" task on page 2-25
Step
NTP-G75 Monitor Transponder and Muxponder Performance
(Table 9-4) where you want to view the optical
Chapter 11, "Change DWDM Card Settings."
at the node that you want to monitor. If you
2.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Chapter 7, "Create Channels
9-19