Cisco ONS 15454 DWDM Installation And Operation Manual page 243

Chapter 3 Turn Up a Node
1 West OPT-BST LINE RX to east OPT-BST or OSC-CSM
LINE TX on adjacent node
2
West OPT-BST LINE TX to east OPT-BST or OSC-CSM
LINE RX on adjacent node
3 West OPT-BST OSC TX to west OSCM RX
4
West OPT-BST OSC RX to west OSCM TX
Plug one end of a fiber into the west OPT-BST or OSC-CSM LINE TX connector.
Step 2
Step 3 Route the fiber cable on the card faceplate through the fiber clip on the faceplate, if provided. (Fiber clips
are factory-attached to the faceplates of 32MUX-O, 32DMX-O, OSCM, OPT-PRE, and OPT-BST
cards.)
Route the fiber cable through the cable-routing channel and cutout on the appropriate side of the shelf
Step 4
assembly, as necessary
When you close the fiber-storage tray, the cables must not be pinched, and the cable bend radius must
Caution
be equal to or greater than the minimum radius that is recommended in your site specifications. As you
route each cable through the fiber-storage tray, make sure that adequate cable slack remains.
Plug the other end of the fiber cable into the adjacent node east OPT-BST or OSC-CSM LINE RX
Step 5
connector. Repeat in the other direction (east to west, TX to RX). Always connect the west line ports to
the adjacent node east line ports.
Note
If OSCM cards are not installed, continue with
Step 6
shelf, complete Steps
side, complete Steps
complete Steps
a.
b.
c.
d.
Repeat Steps
Step 7
Return to your originating procedure (NTP).
Step 8
September 2005
DLP-G65 Install Fiber-Optic Cables for OSC Link Terminations Between Two Adjacent Nodes
(Figure 15-35 on page
Cards display an SF LED after the OSC terminations are created (see the
OSC Terminations" procedure on page
correctly. For example, an RX port is connected to another RX port or a TX port is connected to
another TX port.
a through d. If an OSCM is installed on the west side of the shelf, but not the east
a and b only. If the OSCM is installed on the east side of the shelf but not the west,
c and d only.
Plug one end of a fiber into the west OPT-BST OSC RX connector and the other end into west
OSCM OSC TX connector.
Plug another fiber into the west OSCM OSC RX connector and the other end to the west OPT-BST
OSC TX connector.
Plug one end of a fiber into the east OPT-BST OSC RX connector and the other end into the east
OSCM TX connector.
Plug another fiber into the east OSCM OSC RX connector and the other end to the east OPT-BST
OSC TX connector.
2 and 6 at each node in the network. If this is the final node, continue with
5 East OSCM TX to east OPT-BST OSC RX
6
East OSCM RX to east OPT-BST OSC TX
7 East OPT-BST LINE TX to west OPT-BST or
OSC-CSM LINE RX on adjacent node
8
East OPT-BST LINE RX to west OPT-BST or
OSC-CSM LINE TX on adjacent node
15-37).
3-84) if transmit and receive fibers are not connected
Step 7. If OSCM cards are installed on both sides of the
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
"NTP-G38 Provision
Step 8.
3-53