Cisco ONS 15454 DWDM Installation And Operation Manual page 440

DLP-G101 View Optical Channel Network Connection Information
• To view circuits that originate, terminate, or pass through a specific card, in node view, double-click
the card containing the circuits you want to view.
Note
Step 2 Click the Circuits tab. The Circuits tab shows the following information:
• Circuit Name—Name of the circuit. The circuit name can be manually assigned or automatically
generated.
Type—Circuit types are OCHNC.
•
Note
Size—Circuit size. OCHNC sizes are Equipped not specific, Multi-rate, 2.5 Gbps No FEC (forward
•
error correction), 2.5 Gbps FEC, 10 Gbps No FEC, and 10 Gbps FEC.
Note
• OCHNC Wlen—The wavelength provisioned for the OCHNC. See
of channels and wavelengths.
Direction—The circuit direction, either two-way or one-way.
•
OCHNC Dir—The line direction of the OCHNC, either East to West or West to East. If the direction
•
is West to East, the channel exits from the node through the LINE-TX port of the OSC-CSM-E or
OPT-BST-E, named the East Side Card by Cisco MetroPlanner (typically these cards are hosted by
Slot 17). If the direction is East to West, the channel exits from the node through the LINE-TX port
of OSC-CSM-W or OPT-BST-W, named the West Side Card by Cisco MetroPlanner (typically these
cards are hosted by Slot 1).
• Protection—The type of circuit protection. See
• Status—The circuit status.
Source—The circuit source in the format: node/slot/port "port name" (if a port name has been
•
assigned by the user, the name will appear in quotes).
Note
Destination—The circuit destination in same format as the circuit source. STSs, VTs, VCs, and
•
tributary units are not applicable to DWDM nodes.
# of VLANS—The number of VLANs used by an Ethernet circuit. VLANs are not applicable to
•
DWDM nodes.
• # of Spans—The number of internode links that constitute the circuit.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
7-4
In node or card view, you can change the scope of the circuits that appear by choosing Card
(in card view), Node, or Network from the Scope drop-down list in the bottom right corner
of the Circuits window.
The following circuit types are not applicable to DWDM nodes: STS, VT, VTT (VT tunnel),
VAP (VT aggregation point), STS-v (STS VCAT circuit), VT-v (VT VCAT circuit), HOP
(high-order circuit), LOP (low-order circuit), VCT (VC low-order tunnel), and VCA
(low-order VCAT circuit).
The following circuit types under the circuit size column are not applicable to DWDM
nodes: STS, VT, VCAT, VC12, VC11, VC3, and VC4.
Table 7-2 on page 7-6
The user can assign a specific port name to every port of any DWDM card after completing
the "DLP-G104 Assign a Name to a Port" task on page
Chapter 7
Table 7-3 on page 7-11
Table 7-1 on page 7-5 for a list of protection types.
lists the circuit statuses that can appear.
7-10.
Create Channels and Circuits
for a list
September 2005