Ntp- G28 Set Up Snmp - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 3 Turn Up a Node
Always verify that the IP-over-CLNS tunnel type you choose is supported by the equipment at the other
Caution
end of the tunnel.
•
•
•
•
Click OK.
Step 4
Provision the other tunnel end point using the documentation provided by the manufacturer of the third
Step 5
party vendor NE.
Step 6 Return to your originating procedure (NTP).
NTP-G28 Set Up SNMP
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
If you are already logged in, continue with Step 2.
Step 2 In node view, click the Provisioning > SNMP tabs.
In the Trap Destinations area, click Create.
Step 3
Complete the following in the Create SNMP Trap Destination dialog box
Step 4
•
•
September 2005
IP Address—Enter the IP address of the IP-over-CLNS tunnel destination.
IP Mask—Enter the IP address subnet mask of the IP-over-CLNS destination.
OSPF Metric—Enter the OSPF metric for sending packets across the IP-over-CLNS tunnel. The
OSPF metric, or cost, is used by OSPF routers to calculate the shortest path. The default is 110.
Normally, it is not be changed unless you are creating multiple tunnel routes and want to prioritize
routing by assigning different metrics.
NSAP Address—Enter the destination NE or OSI router NSAP address.
This procedure provisions the SNMP parameters so that you can use
SNMP management software with the ONS 15454.
None
NTP-G22 Verify Common Card Installation, page 3-4
Required if SNMP is used at your installation.
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
Destination IP Address—Type the IP address of your network management system (NMS). If the
node you are logged into is an ENE, set the destination address to the GNE.
Community—Type the SNMP community name. For a description of SNMP community names,
refer to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH
Troubleshooting Guide.
The community name is a form of authentication and access control. The community name
Note
assigned to the ONS 15454 is case-sensitive and must match the community name of the
NMS.
at the node where you want to set up SNMP.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G28 Set Up SNMP
(Figure 3-8):
3-35