Table 11-14 Multiplexer And Demultiplexer Card Optical Line Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer Cards
DLP-G208 Change Optical Line Settings for Multiplexer and Demultiplexer
Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the multiplexer or demultiplexer card where you want to change the optical
Step 1
line settings.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Modify any of the settings described in
Step 3
followed by the SDH option. The provisionable parameters are listed in the options column in the table.
Table 11-14 Multiplexer and Demultiplexer Card Optical Line Settings
Parameter Description
Port # (Display only) Displays the port number.
Port Name Provides the ability to assign the specified port a
name.
Admin State Sets the port service state unless network
conditions prevent the change. For more
information about administrative states, see
Appendix C, "DWDM Administrative and Service
States."
Line Direction Provides the ability to associate a card with the line
direction. CTC automatically configures the line
direction during node setup. To change this setting,
you must change the Cisco MetroPlanner site plan
and import it to the node.
Service State Identifies the autonomously generated state that
gives the overall condition of the port. Service
states appear in the format: Primary State-Primary
State Qualifier, Secondary State. For more
information about service states, see
"DWDM Administrative and Service States."
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
11-24
This task changes the optical line settings for 32MUX-O, 32DMX-O,
32DMX, and 4MD-xx.x multiplexer and demultiplexer cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table 11-14. In the Options column, the SONET option is
Options
Displays port number and TX or RX.
User-defined. Name can be up to 32 alphanumeric/
special characters. Blank by default. Double-click,
enter the name, and press Enter.
See the
page 7-10.
From the drop-down list, choose one of the following:
IS/Unlocked
•
IS,AINS/Unlocked,automaticInService
•
OOS,DSBLD/Locked,disabled
•
OOS,MT/Locked,maintenance
•
From the drop-down list, choose one of the following:
East to West
•
West to East
•
Display only
• IS-NR/Unlocked-enabled
• OOS-AU,AINS/Unlocked-disabled,
automaticInService
Appendix C,
OOS-MA,DSBLD/Locked-enabled,disabled
•
• OOS-MA,MT/Locked-enabled,maintenance
Chapter 11 Change DWDM Card Settings
"DLP-G104 Assign a Name to a Port" task on
September 2005