Before You Begin - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G247 Change AIC-I Card Orderwire Settings
Step 5 Click Apply.
Return to your originating procedure (NTP).
Step 6
DLP-G247 Change AIC-I Card Orderwire Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
When provisioning orderwire for ONS 15454s residing in a ring, do not provision a complete orderwire
Caution
loop. For example, a four-node ring typically has east and west ports provisioned at all four nodes.
However, to prevent orderwire loops, provision two orderwire ports (east and west) at all but one of the
ring nodes.
Before you begin, make a list of the ONS 15454 slots and ports that require orderwire communication.
Tip
In node view, double-click the AIC-I card to display it in card view.
Step 1
Click the Provisioning > Local Orderwire tabs or the Provisioning > Express Orderwire tabs,
Step 2
depending on the orderwire path that you want to change. Provisioning steps are the same for both types
of orderwire.
Step 3 If needed, adjust the transmit (Tx) and receive (Rx) dBm values by moving the slider to the right or left
for the headset type (four-wire or two-wire) that you will use. In general, you should not need to adjust
the dBm values.
If you want to turn on the audible alert (buzzer) for the orderwire, check the Buzzer On check box.
Step 4
Click Apply.
Step 5
Return to your originating procedure (NTP).
Step 6
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
11-44
This task changes orderwire settings on the AIC-I card.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 11 Change DWDM Card Settings
September 2005