Cisco ONS 15454 DWDM Installation And Operation Manual page 259

Chapter 3 Turn Up a Node
• The west OPT-BST or OSC-CSM COM TX port is connected to the west OPT-PRE COM RX port.
The west OPT-PRE COM TX port is connected to the west 32WSS COM RX port.
•
The west OPT-BST or OSC-CSM COM RX port is connected to the west 32WSS COM TX port.
•
The west OPT-BST (if installed) OSC TX port is connected to the west OSCM RX port.
•
The west OPT-BST (if installed) OSC RX port is connected to the west OSCM TX port.
•
The west 32WSS EXP TX port is connected to the east 32WSS EXP RX port.
•
The west 32WSS EXP RX port is connected to the east 32WSS EXP TX port.
•
The west 32WSS DROP TX port is connected to the west 32DMX COM RX port.
•
The east OPT-BST or OSC-CSM COM TX port is connected to the east OPT-PRE COM RX port.
•
The east OPT-PRE COM TX port is connected to the east 32WSS COM RX port.
•
The east OPT-BST or OSC-CSM COM RX port is connected to the east 32WSS COM TX port.
•
The east OPT-BST (if installed) OSC TX port is connected to the east OSCM RX port.
•
The east OPT-BST (if installed) OSC RX port is connected to the east OSCM TX port.
•
The east 32WSS DROP TX port is connected to the east 32DMX COM RX port.
•
Figure 3-16
Note
September 2005
shows an example of an amplified ROADM node with cabling.
Figure 3-16 is an example. Always install fiber-optic cables based on the Cisco MetroPlanner
Internal Connections table for your site.
DLP-G71 Install Fiber-Optic Cables for an ROADM Node
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-69