Ntp- G89 Change Snmp Settings - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
NTP-G89 Change SNMP Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Step 2.
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
Complete the
Step 4
Stop. You have completed this procedure.
DLP-G197 Modify SNMP Trap Destinations
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Provisioning > SNMP tabs.
Step 1
Select a trap from the Trap Destinations area.
Step 2
For a description of SNMP traps, refer to the Cisco ONS 15454 Troubleshooting Guide or the
Cisco ONS 15454 SDH Troubleshooting Guide.
Highlight the Destination row field entry in the Community column and change the entry to another valid
Step 3
community name.
The community name is a form of authentication and access control. The community name assigned to
the ONS 15454 is case-sensitive and must match the community name of the network management
system (NMS).
If needed, modify the UDP port in the UDP Port field. The default UDP port for SNMP is 162.
Step 4
September 2005
This procedure modifies the SNMP settings for the ONS 15454.
None
NTP-G28 Set Up SNMP, page 3-35
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page
"NTP-G103 Back Up the Database" procedure on page
DLP-G197 Modify SNMP Trap Destinations, page 10-61
DLP-G198 Delete SNMP Trap Destinations, page 10-62
"NTP-G103 Back Up the Database" procedure on page
This task modifies the SNMP trap destinations on an ONS 15454 including
community name, default User Datagram Protocol (UDP) port, SNMP trap
version, and maximum traps per second.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
2-25. If you are already logged in, continue with
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G89 Change SNMP Settings
13-2.
13-2.
10-61