Ntp- G49 Perform The Oadm Active Node Acceptance Test On A Symmetric Node With Osc-Csm Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G49 Perform the OADM Active Node Acceptance Test on a Symmetric Node with OSC-CSM Cards
NTP-G49 Perform the OADM Active Node Acceptance Test on a
Symmetric Node with OSC-CSM Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
perform the acceptance test. If you are already logged in, continue with
From the View menu, choose Go to Network View.
Step 2
Click the Alarms tab.
Step 3
a.
b.
In node view, click the Provisioning > WDM-ANS > Port Status tabs. Verify that all statuses under
Step 4
Link Status are Success - Changed, Success - Unchanged, or Not Applicable. If not, complete the
"NTP-G37 Run Automatic Node Setup" procedure on page
Step 5 Check the Cisco MetroPlanner site configuration file to verify the presence of added and dropped bands
(including 4 channels at 100 GHz) configured in pass-through mode in either direction.
Note
If no bands are configured in pass-through mode, continue with
Step 6
pass-through mode, mark it and skip the related optical test for the express, add, and drop sections. Band
pass-through connections are verified separately.
Check the site configuration file from Cisco MetroPlanner to verify the presence of dropped or added
Step 7
channels configured in pass-through mode in either direction.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
4-36
This procedure checks the integrity of all the optical connections inside an
OADM node with OSC-CSM and OPT-BST cards installed on both the
east and west sides of the shelf. Three connection types are tested:
•
•
•
A tunable laser or eight TXP_MR_2.5G cards covering the 32 C-band
wavelengths (see
An optical power meter or optical spectrum analyzer
2 bulk attenuators (10 dB) with LC connectors
Chapter 3, "Turn Up a Node."
Required
Onsite
Superuser
"DLP-G46 Log into CTC" task on page 2-25
Verify that the alarm filter is not on. See the
as necessary.
Verify that no equipment (EQPT) alarms appear indicating equipment failure or other hardware
problems. If equipment failure alarms appear, investigate and resolve them before continuing. Refer
to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting
Guide for procedures.
Configuring a band in pass-through mode means that the band is dropped in one direction by an
AD-xB-xx.x card on one side (east or west) of the node, then added by another AD-xB-x.xx card
on the opposite side in the same direction. The band is not terminated inside the node.
Express
Pass-through
Add/Drop
Table 4-1)
"DLP-G128 Disable Alarm Filtering" task on page 8-28
Chapter 4 Perform Node Acceptance Tests
at the OADM node where you want to
Step 2.
3-83.
Step 7. If a band is configured in
September 2005