Table 1-5 Lan Pin Assignments; Dlp- G22 Install Lan Wires On The Mic-C/T/P (Etsi Only) - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G22 Install LAN Wires on the MIC-C/T/P (ETSI Only)
DLP-G22 Install LAN Wires on the MIC-C/T/P (ETSI Only)
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note Rather than using the LAN connection port on the MIC-C/T/P, you can use the LAN connection port on
the TCC2/TCC2P card if preferred. Use either the MIC-C/T/P connection or the TCC2/TCC2P card
connection. You cannot use the LAN connection port on the MIC-C/T/P and the LAN connection port
on the TCC2/TCC2P card simultaneously; however, it is possible for you to make a direct connection
from a computer to the LAN connection port on the TCC2/TCC2P card while the LAN connection port
on the MIC-C/T/P is in use as long as the computer connected directly to the TCC2/TCC2P card is not
connected to a LAN.
Using 0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire or CAT-5 UTP Ethernet cable, connect the wires
Step 1
to the RJ-45 connector according to
Table 1-5
LAN
LAN 1
Connecting to DCE
(a hub or switch)
Cross-over Ethernet cable
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
1-52
This task installs the LAN wires on the ONS 15454 ETSI MIC-C/T/P.
Standard CAT-5 UTP Ethernet cable (straight-through for data terminating
equipment [DTE] or cross-over for data circuit-terminating equipment
[DCE])
or
RJ-45 connector
Crimping tool for RJ-45 connector
0.51 mm² or 0.64 mm² (#22 or #24 AWG) wire, preferably CAT-5 UTP
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), page
1-28
As needed
Onsite
None
Table
LAN Pin Assignments
RJ-45 Pin
1
1
2
3
4
5
6
7
8
Chapter 1 Install the Shelf and Common Control Cards
1-5.
RJ-45 Pin
3
6
1
4
5
2
7
8
Function
PNMSRX+
white/green
PNMSRX–
green
PNMSTX
white/orange
—
—
PNMSTX–
orange
—
—
August 2005