Dlp- G289 Provision Additional Manual Area Addresses - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G289 Provision Additional Manual Area Addresses
The Router 1 manual area address, System ID, and Selector "00" create the node NSAP address.
Note
Changing the Router 1 manual area address changes the node's NSAP address.
The System ID for Router 1 is the node MAC address. The System IDs for Routers 2 and 3 are created
Note
by adding 1 and 2 respectively to the Router 1 System ID. You cannot edit the System IDs.
Click the Provisioning > OSI > Routers > Setup tabs.
Step 1
Chose the router you want provision and click Edit. The OSI Router Editor dialog box appears.
Step 2
In the OSI Router Editor dialog box:
Step 3
a.
b.
c.
d.
Return to your originating procedure (NTP).
Step 4
DLP-G289 Provision Additional Manual Area Addresses
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Click the Provisioning > OSI > Routers > Setup tabs.
Chose the router where you want provision an additional manual area address and click Edit. The OSI
Step 2
Router Editor dialog box appears.
Step 3 In the OSI Router Editor dialog box:
a.
b.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-32
Check Enable Router to enable the router and make its primary area address available for editing.
Click the manual area address, then click Edit.
In the Edit Manual Area Address dialog box, edit the primary area address in the Area Address field.
If you prefer, click Use Mask and enter the edits in the Masked NSAP Entry dialog box. The address
(hexadecimal format) can be 8 to 24 alphanumeric characters (0–9, a–f) in length.
Click OK successively to close the following dialog boxes: Masked NSAP Entry (if used), Edit
Manual Area Address, and OSI Router Editor.
This task provisions the OSI manual area addresses. One primary area and
two additional manual areas can be created for each virtual router.
None
NTP-G22 Verify Common Card Installation, page 3-4
DLP-G288 Provision OSI Routers, page 3-31
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Check Enable Router to enable the router and make its primary area address available for editing.
Click the manual area address, then click Add.
Chapter 3 Turn Up a Node
September 2005