Ntp- G15 Install The Common Control Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 1 Install the Shelf and Common Control Cards
Step 2 Insert the appropriate Y-cable module into the FlexLayer shelf assembly. Use a Phillips screwdriver to
install the two accompanying screws.
Repeat this task as necessary for each Y-cable module you want to install
Step 3
Step 4 Return to your originating procedure (NTP).
NTP-G15 Install the Common Control Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
Warning
touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. Plug the wristband
cable into the ESD jack located on the lower-right outside to edge of the shelf assembly.
If protective clips are installed on the backplane connectors of the cards, remove the clips before
Note
installing the cards.
If you install a card incorrectly, the FAIL LED flashes continuously.
Note
Complete the
Step 1
Note
Step 2 Complete the
Step 3 Continue with the
August 2005
This procedure describes how to install the common control cards.
Redundant TCC2/TCC2P cards
AIC-I card (optional)
NTP-G2 Install the Shelf Assembly, page 1-8
NTP-G14 Install DWDM Equipment, page 1-66
Required
Onsite
Provisioning or higher
"DLP-G33 Install the TCC2 or TCC2P Card" task on page
If you install the wrong card in a slot, see the
procedure on page 12-1.
"DLP-G34 Install the AIC-I Card" task on page
"NTP-G16 Perform the Shelf Installation Acceptance Test" procedure on page
"NTP-G107 Remove and Replace DWDM Cards"
1-75, if necessary.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
NTP-G15 Install the Common Control Cards
(Figure 15-12 on page
1-72.
15-14).
1-76.
1-71