Figure 3-4 Selecting The Save Configuration Option; Figure 3-5 Saving And Rebooting The Tcc2/Tcc2P - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G57 Set the IP Address, Default Router, and Network Mask Using the LCD
Tip
Press the Port button to cycle the IP address or subnet mask to the correct digit.
Step 5
When the change is complete, press the Status button to return to the Node menu.
Step 6
Repeatedly press the Port button until the Save Configuration option appears
Step 7
Figure 3-4
FAN FAIL
Press the Status button to choose the Save Configuration option.
Step 8
A Save and REBOOT message appears
Figure 3-5
FAN FAIL
Press the Slot button to apply the new IP address configuration or press Port to cancel the configuration.
Step 9
Saving the new configuration causes the TCC2/TCC2P cards to reboot. During the reboot, a "Saving
Changes - TCC Reset" message displays on the LCD. The LCD returns to the normal alternating display
after the TCC2/TCC2P reboot is complete.
Note
Return to your originating procedure (NTP).
Step 10
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-16
The Slot, Status, and Port button positions correspond to the positions of the commands shown
on the LCD. For example, in
and the Port button to invoke the Done command.
Selecting the Save Configuration Option
Slot Status
CRIT MAJ
Saving and Rebooting the TCC2/TCC2P
Slot Status
CRIT MAJ
The IP address and default router must be on the same subnet. If not, you cannot apply the
configuration.
Figure 3-3, you press the Slot button to invoke the Next command
Port
Slot-0
Status=Save Cfg.
MIN
(Figure 3-5).
Port
Save and REBOOT?
<Apply
MIN
Chapter 3 Turn Up a Node
(Figure 3-4).
Revert>
September 2005