Dlp- G287 Add A Tarp Manual Adjacency Table Entry - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 10 Manage the Node
Step 5 Return to your originating procedure (NTP).
DLP-G287 Add a TARP Manual Adjacency Table Entry
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In the node view, click the Provisioning > OSI > TARP > MAT tabs.
Step 1
Click Add.
Step 2
In the Add TARP Manual Adjacency Table Entry dialog box, enter the following:
Step 3
•
•
Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the Add Static
Step 4
Entry dialog box.
Return to your originating procedure (NTP).
Step 5
DLP-G292 Remove a TARP Manual Adjacency Table Entry
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
If TARP manual adjacency is the only means of communication to a group of nodes, loss of visibility
Caution
will occur when the adjacency table entry is removed.
September 2005
This task adds an entry to the TARP manual adjacency table (MAT). Entries
are added to the MAT when the ONS 15454 must communicate across
routers or non-SONET NEs that lack TARP capability.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Level—Sets the TARP Type Code that will be sent:
– Level 1—Indicates that the adjacency is within the same area as the current node. The entry
generates Type 1 PDUs.
Level 2—Indicates that the adjacency is in a different area from the current node. The entry
–
generates Type 2 PDUs.
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
This task removes an entry from the TARP MAT.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
DLP-G287 Add a TARP Manual Adjacency Table Entry
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
10-13