Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
NTP-G97 Modify Line Settings and PM Parameter Thresholds for
MXP_2.5G_10G and MXP_2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
muxponder card settings. If you are already logged in, continue with
Step 2 As needed, complete the
existing transmission settings.
Step 3 Perform any of the following tasks as needed:
•
•
•
•
•
•
•
•
As needed, complete the
Step 4
Stop. You have completed this procedure.
September 2005
NTP-G97 Modify Line Settings and PM Parameter Thresholds for MXP_2.5G_10G and MXP_2.5G_10E Cards
This procedure changes the line and threshold settings for
MXP_2.5G_10G and MXP_2.5G_10E muxponder cards.
None
NTP-G32 Install the Transponder and Muxponder Cards, page
DLP-G63 Install an SFP or XFP, page 3-45
DLP-G277 Provision a Multirate PPM, page 5-3
DLP-G278 Provision the Optical Line Rate, page 5-6
As needed
Onsite or remote
Provisioning or higher
"DLP-G46 Log into CTC" task on page 2-25
"NTP-G103 Back Up the Database" procedure on page 13-2
DLP-G222 Change Card Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page 5-32
DLP-G223 Change Line Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page 5-34
DLP-G224 Change Section Trace Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page
5-36
DLP-G225 Change Trunk Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page 5-38
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page
5-39
DLP-G303 Provision the MXP_2.5G_10G and MXP_2.5G_10E Trunk Port Alarm and TCA
Thresholds, page 5-41
DLP-G304 Provision the MXP_2.5G_10G and MXP_2.5G_10E Client Port Alarm and TCA
Thresholds, page 5-43
DLP-G228 Change Line OTN Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards, page 5-44
"NTP-G103 Back Up the Database" procedure on page
at the node where you want to change the
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-43.
(if necessary)
(if necessary)
Step 2.
to preserve the
13-2.
5-31