Dlp- G231 Change Section Trace Settings For Txp_Mr_2.5G And Txpp_Mr_2.5G Cards - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
DLP-G231 Change Section Trace Settings for TXP_MR_2.5G and
TXPP_MR_2.5G Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
This task only applies to SONET services.
Note
In node view, double-click the TXP_MR_2.5G or TXPP_MR_2.5G card where you want to change the
Step 1
section trace settings.
Click the Provisioning > Line > Section Trace tabs.
Step 2
Step 3 Modify any of the settings described in
Table 5-31
Parameter
Port
Trace Mode
Section Trace
String Size
Transmit
September 2005
DLP-G231 Change Section Trace Settings for TXP_MR_2.5G and TXPP_MR_2.5G Cards
This task changes the section trace settings for TXP_MR_2.5G and
TXPP_MR_2.5G transponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
TXP_MR_2.5G and TXPP_MR_2.5G Transponder Card Section Trace Settings
Description
(Display only) Port number.
Sets the trace mode.
Sets the trace string size.
Displays the current transmit string; sets
a new transmit string. You can click the
button on the right to change the display.
Its title changes, based on the current
display mode. Click Hex to change the
display to hexadecimal (button changes to
ASCII); click ASCII to change the
display to ASCII (button changes to Hex).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-31.
Options
• 1
2
•
3 (TXPP_MR_2.5G only)
•
Off/None
•
Manual
•
1 byte
•
16 byte
•
String of trace string size
5-53