Ntp- G118 Replace The Ansi Shelf Plastic Lower Backplane Cover - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G118 Replace the ANSI Shelf Plastic Lower Backplane Cover
Figure 13-14
Note
When the circuit repair is complete, the Circuits Repaired dialog box appears.
Click OK.
Step 27
In node view of the new node, click the Circuits tab. Check to ensure that all circuits listed have a status
Step 28
of DISCOVERED. If all circuits listed are not DISCOVERED, call the Cisco TAC at (800) 553-2447 to
open a Return Material Authorization (RMA).
Stop. You have completed this procedure.
NTP-G118 Replace the ANSI Shelf Plastic Lower Backplane
Cover
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Use the Phillips screwdriver to unscrew the five retaining screws that hold the metal cover in place.
Step 2 Grasp the metal cover on each side.
Gently pull the metal cover away from the backplane.
Step 3
Place the plastic cover against the shelf assembly and align the screw holes on the cover and the shelf
Step 4
assembly
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-40
Circuit Repair Information
The CTC session freezes until all circuits are repaired. Circuit repair can take up to five minutes
or more depending on the number of circuits provisioned.
This procedure replaces the plastic cover located at the bottom rear of
the ONS 15454 ANSI shelf.
Phillips screwdriver
None
As needed
Onsite
None
(Figure 13-15).
Chapter 13 Maintain the Node
September 2005