Lan Connections - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 15 Shelf Hardware Reference

15.14.3 LAN Connections

Use the LAN pins on the ONS 15454 ANSI backplane to connect the ONS 15454 ANSI to a workstation
or Ethernet LAN, or to a LAN modem for remote access to the node. You can also use the LAN port on
the TCC/TCC2P faceplate to connect a workstation or to connect the ONS 15454 ANSI to the network.
Table 15-14
Before you can connect an ONS 15454 ANSI to other ONS 15454 ANSI shelves or to a LAN, you must
change the default IP address that is shipped with each ONS 15454 ANSI (192.1.0.2).
Table 15-14
Pin Field
LAN 1
Connecting to data circuit-terminating
equipment (DCE
LAN 1
Connecting to data terminal equipment
(DTE) (a PC/workstation or router)
1. The Cisco ONS 15454 ANSI is DCE.
15.14.4 TL1 Craft Interface Installation
You can use the craft pins on the ONS 15454 ANSI backplane or the EIA/TIA-232 port on the
TCC2/TCC2P faceplate to create a VT100 emulation window to serve as a TL1 craft interface to the
ONS 15454 ANSI. Use a straight-through cable to connect to the EIA/TIA-232 port.
the pin assignments for the CRAFT pin field.
You cannot use the craft backplane pins and the EIA/TIA-232 port on the TCC2/TCC2P card
Note
simultaneously.
Table 15-15
Pin Field
Craft
September 2005
shows the LAN pin assignments.
LAN Pin Assignments
1
, a hub or switch)
Craft Interface Pin Assignments
Contact
A1
A2
A3
A4
Backplane Pins RJ-45 Pins
B2 1
A2 2
B1 3
A1 6
B1 1
A1 2
B2 3
A2 6
Function
Receive
Transmit
Ground
DTR
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
15.14.3 LAN Connections
Table 15-15 shows
15-47