Dlp- G299 View Es-Is Routing Information Base - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G299 View ES-IS Routing Information Base
Step 2 View the following RIB information for Router 1:
•
•
•
•
Step 3 If additional routers are enabled, you can view their RIBs by choosing the router number in the Router
field and clicking Refresh.
Return to your originating procedure (NTP).
Step 4
DLP-G299 View ES-IS Routing Information Base
Purpose
Tools/Equipment
Prerequisite procedures
Required/As needed
Onsite/Remote
Security Level
In node view, click the Maintenance > OSI > ES-IS RIB tabs.
Step 1
View the following RIB information for Router 1:
Step 2
•
•
•
•
If additional routers are enabled, you can view their RIBs by choosing the router number in the Router
Step 3
field and clicking Refresh.
Step 4 Return to your originating procedure (NTP).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
13-10
Subnet Type—Indicates the OSI subnetwork point of attachment type used to access the destination
address. Subnet types include SDCC, LDCC, GCC, OSC, and LAN.
Location—Indicates the OSI subnetwork point of attachment. For data communications channel
(DCC) subnets, the slot and port are displayed. LAN subnets are shown as LAN.
Destination Address—The destination Network Service Access Point (NSAP) of the IS.
MAC Address—For destination NEs that are accessed by LAN subnets, the NE's MAC address.
This task allows you to view the ES-IS protocol RIB. ES-IS is an OSI
protocol that defines how end systems (hosts) and intermediate systems
(routers) learn about each other. For ESs, the ES-IS RIB shows the network
view from the perspective of the ES node. For ISs, the ES-IS RIB shows the
network view from the perspective of the IS node.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Subnet Type—Indicates the OSI subnetwork point of attachment type used to access the destination
address. Subnet types include SDCC, LDCC, GCC, OSC, and LAN.
Location—Indicates the subnet interface. For DCC subnets, the slot and port are displayed. LAN
subnets are shown as LAN.
Destination Address—The destination IS NSAP.
MAC Address—For destination NEs that are accessed by LAN subnets, the NE's MAC address.
Chapter 13 Maintain the Node
September 2005