Cisco ONS 15454 DWDM Installation And Operation Manual page 216

NTP-G132 Provision OSI
This procedure requires an understanding of OSI protocols, parameters, and functions. Before you begin,
Caution
review the OSI reference sections in
Do not begin this procedure until you know the role of the ONS 15454 within the OSI and IP network.
Caution
This procedure requires provisioning of non-ONS equipment including routers and third party NEs. Do
Note
not begin until you have the capability to complete that provisioning.
Step 1 Complete the
OSI routing mode. If you are already logged in, continue with Step 2.
Step 2 As needed, complete the following tasks:
• DLP-G283 Provision OSI Routing Mode, page
• DLP-G284 Provision the TARP Operating Parameters, page
DLP-G285 Add a Static TID to NSAP Entry to the TARP Data Cache, page
•
task as needed.
• DLP-G287 Add a TARP Manual Adjacency Table Entry, page
• DLP-G288 Provision OSI Routers, page
DLP-G289 Provision Additional Manual Area Addresses, page
•
DLP-G290 Enable the OSI Subnet on the LAN Interface, page
•
DLP-G291 Create an IP-Over-CLNS Tunnel, page
•
Stop. You have completed this procedure.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-26
Chapter 22, "Management Connectivity Reference."
"DLP-G46 Log into CTC" task on page 2-25 at the node where you want to provision the
3-27—Complete this task first.
3-28—Complete this task second.
3-31—Complete this task as needed.
3-31—Complete this task as needed.
3-32—Complete this task as needed.
3-33—Complete this task as needed.
3-34—Complete this task as needed.
Chapter 3 Turn Up a Node
3-30—Complete this
September 2005