Dlp- G132 Refresh Pm Counts At One-Day Intervals - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 9 Monitor Performance
Step 2 Click the Performance tab.
If you want to change the PM interval to 15 minutes for a subtab, click the relevant subtab(s), located
Step 3
along the left side of the Performance tab.
Note
If you want to change the PM interval to 15 minutes for a specific port, select the port from the Ports
Step 4
drop-down list (where available).
Go to any of the tabs, subtabs, or ports (found in the Ports drop-down list where available) for that card
Step 5
where you want to set the PM count interval by clicking on the desired subtab and choosing the port from
the drop-down list.
Step 6 Click the 15 min radio button.
Step 7 Click Refresh. PM parameters appear in 15-minute intervals synchronized with the time of day.
Step 8 View the Curr column to find PM counts for the current 15-minute interval.
Each monitored performance parameter has corresponding threshold values for the current time period.
If the value of the counter exceeds the threshold value for a particular 15-minute interval, a threshold
crossing alert (TCA) is raised. The number represents the counter value for each specific PM parameter.
View the Prev-n columns to find PM counts for the previous 15-minute intervals.
Step 9
Note
Return to your originating procedure (NTP).
Step 10
DLP-G132 Refresh PM Counts at One-Day Intervals
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view (single-shelf mode), or shelf view (multishelf mode), double-click the DWDM, TXP, or
Step 1
MXP card where you want to change the PM interval. The card view appears.
Click the Performance tab.
Step 2
September 2005
Performance subtabs vary, depending on the card viewed.
If a complete 15-minute interval count is not possible, the value appears with a yellow
background. An incomplete or incorrect count can be caused by monitoring for less than
15 minutes after the counter started, changing the node timing settings, changing the time zone
settings, replacing a card, resetting a card, or changing port service states. When the problem is
corrected, the subsequent 15-minute interval appears with a white background.
This task changes the window view to display PM parameters in 1-day
intervals.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
DLP-G132 Refresh PM Counts at One-Day Intervals
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
9-3