Dlp- G150 View Payload Utilization Pm Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G150 View Payload Utilization PM Parameters
Note
Return to your originating procedure (NTP).
Step 5
DLP-G150 View Payload Utilization PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to view PM
counts. The card view appears.
Click the Performance > Payload PM > Utilization tabs
Step 2
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
9-28
To refresh, reset, or clear PM counts, see the
page 9-2.
This task enables you to view line utilization PM counts on an
MXP_MR_2.5G or MXPP_MR_2.5G card and port to detect possible
performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
Chapter 9
"NTP-G73 Change the PM Display" procedure on
(Figure 9-11).
Monitor Performance
September 2005