Dlp- G254 Place Opt-Bst And Opt-Pre Ports Out Of Service - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 12 Add and Remove Cards and Nodes
Step 7 Continue with the
page
Complete the following tasks or procedures, as needed:
Step 8
•
•
•
•
•
Click the Alarms tab.
Step 9
a.
b.
Stop. You have completed this procedure.
DLP-G254 Place OPT-BST and OPT-PRE Ports Out of Service
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
On the shelf graphic in CTC, double-click the OPT-BST or OPT-PRE card with the ports that you want
Step 1
to put out of service.
Step 2 Click the Provisioning > Optical Line > Parameters tabs.
Step 3 Under Admin State, choose OOS,DSBLD (ANSI) or Locked,disabled (ETSI) for each port that does
not have an OOS-MA,DSBLD or Locked-disabled service state.
Click Apply.
Step 4
Step 5 In the confirmation dialog box, click Yes.
Step 6 Click the Provisioning > Opt Apli Line > Parameters tabs.
September 2005
"NTP-G34 Install Fiber-Optic Cables on DWDM Cards and DCUs" procedure on
3-48.
If you switched a Y-cable protection group in
Force Y-Cable or Splitter Protection Switch" task on page
If you deleted circuits in
Network Connections" task on page
If you switched the timing reference in
Reference" procedure on page
If you deleted an OSC or GCC termination in
Terminations" procedure on page 3-84
page 7-14.
If you placed OPT-PRE or OPT-BST cards out of service, complete the
and OPT-PRE Ports In Service" task on page
Verify that the alarm filter is not on. See the
as necessary.
Verify that no unexplained alarms appear on the network. If alarms appear, investigate and resolve
them. Refer to the Cisco ONS 15454 Troubleshooting Guide or the Cisco ONS 15454 SDH
Troubleshooting Guide for procedures.
DLP-G254 Place OPT-BST and OPT-PRE Ports Out of Service
Step
Step 3, complete the "DLP-G105 Provision DWDM Optical Channel
7-10.
Step 3, complete the
13-17.
Step
or the "DLP-G76 Provision GCC Terminations" task on
12-4.
"DLP-G128 Disable Alarm Filtering" task on page 8-28
This task places OPT-BST and OPT-PRE card ports out of service in
preparation for card removal.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3, complete the "DLP-G180 Clear a Manual or
10-36.
"NTP-G112 Change the Node Timing
3, complete the "NTP-G38 Provision OSC
"DLP-G318 Place OPT-BST
12-3