Ntp- G39 Verify Oscm And Osc-Csm Transmit Power - Cisco ONS 15454 DWDM Installation And Operation Manual

NTP-G39 Verify OSCM and OSC-CSM Transmit Power
Click Finish. Ports are automatically placed in service. Until network OSC connections between
Step 7
adjacent nodes are created, the following alarms might appear:
•
•
•
Note
Stop. You have completed this procedure.
NTP-G39 Verify OSCM and OSC-CSM Transmit Power
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
OSCM or OSC-CSM transmit power. If you are already logged in, continue with
In the node view shelf graphic, double-click the west OSCM or OSC-CSM card.
Step 2
Click the Maintenance > ALS tabs.
Step 3
From the ALS Mode drop-down list, choose Disable. Click Apply.
Step 4
If a second OSC-CSM or OSCM card is installed, repeat Steps
Step 5
if you have completed the steps, continue with
Complete one of the following tasks, depending on whether you are checking an OSC-CSM or OSCM
Step 6
card:
•
•
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
3-86
– ISH—Sets the ISH PDU propagation frequency. Intermediate system NEs send ISHs to other
ESs and ISs to inform them about the IS NETs it serves. The default is 10 seconds. The range
is 10 to 1000 seconds.
IIH—Sets the IIH PDU propagation frequency. The IS-IS Hello PDUs establish and maintain
–
adjacencies between ISs. The default is 3 seconds. The range is 1 to 600 seconds.
Metric—Sets the cost for sending packets on the LAN subnet. The IS-IS protocol uses the cost
–
to calculate the shortest routing path. The default metric cost for LAN subnets is 20. It normally
should not be changed.
SDCC Termination Failure alarm on the OSCM or OSC-CSM card
LOS-P alarm on the OC-3 port (Port 1) on the OSCM or OSC-CSM card
OPWR-LFAIL alarm on the OPT-BST or OSC-CSM card
After the OSC termination is created, the line ports are placed in service and span power levels
are checked.
This procedure verifies the transmit power of the ONS 15454 OSCM and
the OSC-CSM cards.
None
NTP-G37 Run Automatic Node Setup, page 3-83
Required
Onsite or remote
Superuser
"DLP-G46 Log into CTC" task on page 2-25
DLP-G313 Verify OSC-CSM Transmit Power, page 3-87
DLP-G314 Verify OSCM Transmit Power, page 3-89
at the node where you want to verify the
2 through
Step 6.
Chapter 3 Turn Up a Node
Step 2.
4 on the second card. If not, or
September 2005