Dlp- G128 Disable Alarm Filtering - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G128 Disable Alarm Filtering
Step 7 Return to your originating procedure (NTP).
DLP-G128 Disable Alarm Filtering
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 At node, network, or card view, click the Alarms tab.
Step 2 Click the Filter tool icon on the right side of the bottom toolbar.
Note
Alarm filtering is enabled if the tool is indented and disabled if the tool is raised (not selected).
If you want alarm filtering disabled when you view conditions, click the Conditions tab and click the
Step 3
Filter tool.
If you want alarm filtering disabled when you view alarm history, click the History tab and click the
Step 4
Filter tool.
Return to your originating procedure (NTP).
Step 5
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
8-28
This task turns off specialized alarm filtering in all network nodes so that
all severities are reported in CTC.
None
DLP-G126 Enable Alarm Filtering, page 8-25
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
The Filter tool icon differs from the Filter button at the bottom left of the screen.
Chapter 8 Manage Alarms
September 2005