Dlp- G106 Delete Optical Channel Network Connections - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G106 Delete Optical Channel Network Connections
•
•
Step 6 Click Next.
In the Circuit Source area, choose the source node from the Node drop-down list.
Step 7
Click Next.
Step 8
In the Circuit Destination area, choose the destination node from the Node drop-down list.
Step 9
Click Finish. The circuit might take a few minutes to come up, depending on the size of the network. If
Step 10
problems persist, refer to the Cisco ONS 15454 DWDM Troubleshooting Guide as necessary.
Return to your originating procedure (NTP).
Step 11
DLP-G106 Delete Optical Channel Network Connections
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
information if it will be recreated.
Consult your network operations center (NOC) or other appropriate personnel to verify that the OCHNC
Step 2
can be safely deleted.
Investigate all network alarms and resolve any problems that might be affected by the OCHNC deletion.
Step 3
Step 4 Choose View > Go to Network View.
Step 5 Click the Circuits tab.
Choose the OCHNCs you want to delete, then click Delete.
Step 6
In the Delete Circuits confirmation dialog box, check Notify when completed, as needed.
Step 7
If checked, the CTC Alerts confirmation dialog box indicates when the OCHNC is deleted. During this
time, you cannot perform other CTC functions. If you are deleting many OCHNCs, waiting for
confirmation might take a few minutes. Circuits are deleted whether or not this check box is checked.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
7-12
OCHNC Direction—Choose the OCHNC direction, either East to West or West to East. If you
choose West to East, the channel will exit the node through the LINE-TX port of the OSC-CSM-E
or OPT-BST-E, named the East Side Card by Cisco MetroPlanner (typically these cards are hosted
by Slot 17). If you choose East to West, the channel will exit the node through the LINE-TX port of
the OSC-CSM-W or OPT-BST-W, named the West Side Card by Cisco MetroPlanner (typically
these cards are hosted by Slot 1).
Bidirectional—Check this check box to create a bidirectional OCHNC; uncheck it to create a
unidirectional OCHNC.
This task deletes circuits and DWDM OCHNCs.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
"NTP-G103 Back Up the Database" procedure on page
Chapter 7 Create Channels and Circuits
13-2, or record the circuit
September 2005