Sdh Payloads - Cisco ONS 15454 DWDM Installation And Operation Manual

DLP-G240 Change MXP_MR_2.5G and MXPP_MR_2.5G Card Line Threshold Settings for SONET or SDH Payloads
Step 2 Click the Provisioning > Line > Section Trace tabs. Tabs and parameter selections vary according to
PPM provisioning.
Modify any of the settings in the Section Trace tab as described in
Step 3
Table 5-45 MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line Section Trace Tab Settings
Parameter Description
Port (Display only) Port number.
Trace Mode Sets the trace mode.
Section Trace Sets the trace string size.
String Size
Transmit Displays the current transmit string; sets a new transmit string.
You can click the button on the right to change the display. Its title
changes, based on the current display mode. Click Hex to change
the display to hexadecimal (button changes to ASCII); click
ASCII to change the display to ASCII (button changes to Hex).
Expected Displays the current expected string; sets a new expected string.
You can click the button on the right to change the display. Its title
changes, based on the current display mode. Click Hex to change
the display to hexadecimal (button changes to ASCII); click
ASCII to change the display to ASCII (button changes to Hex).
Received (Display only) Displays the current received string. You can click
Refresh to manually refresh this display, or check the
Auto-refresh every 5 sec check box to keep this field updated.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-G240 Change MXP_MR_2.5G and MXPP_MR_2.5G Card Line Threshold
Settings for SONET or SDH Payloads
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
5-74
This task changes the line threshold settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards for SONET or SDH payloads.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Chapter 5 Provision Transponder and Muxponder Cards
Table 5-45.
Options
9 (trunk for MXP_MR_2.5G) or 9 and 10
(trunks for MXPP_MR_2.5G)
Off/None
•
Manual
•
1 byte
•
16 byte
•
String of trace string size
String of trace string size
String of trace string size
September 2005