Dlp- G147 View Payload Pm Parameters - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 9 Monitor Performance
Figure 9-6
Performance
Optics PM tab
radio buttons
radio buttons
View the PM parameter names that appear in the Param column of the Current Values and History PM
Step 3
tabs. The PM parameter values appear in the Curr (current) and Prev-n (previous) columns. For PM
parameter definitions, refer to the "Performance Monitoring" chapter in the Cisco ONS 15454
Troubleshooting Guide or the Cisco ONS 15454 SDH Troubleshooting Guide.
Return to your originating procedure (NTP).
Step 4
DLP-G147 View Payload PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the transponder or muxponder card where you want to view PM counts. The
card view appears.
Click the Performance > Payload PM tabs
Step 2
September 2005
Viewing Optics Performance Monitoring Information
Card View
tab
Directions
Intervals
Signal-type Refresh
port menu
This task enables you to view the payload PM counts on a transponder
(TXP_MR_10G, TXP_MR_2.5G, TXPP_MR_2.5G, TXP_MR_10E),
or muxponder (MXP_2.5G_10E, MXP_2.5G_10G) card and port to
detect possible performance problems.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Retrieve or higher
(Figure 9-7).
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
DLP-G147 View Payload PM Parameters
Auto-refresh
button menu
Clear Help
button button
9-23