Dlp- G304 Provision The Mxp_2.5G_10G And Mxp_2.5G_10E Client Port Alarm And Tca Thresholds - Cisco ONS 15454 DWDM Installation And Operation Manual

Chapter 5 Provision Transponder and Muxponder Cards
DLP-G304 Provision the MXP_2.5G_10G and MXP_2.5G_10E Client Port Alarm
and TCA Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
Step 1
client port alarm and TCA settings.
Click the Provisioning > Optics Thresholds tabs. The TCA thresholds are shown by default.
Step 2
Referring to
Step 3
High, RX Power Low, TX Power High, and TX Power Low based on the client interface at the other end.
For additional information about client SFP and XFP interfaces, also known as PPMs, refer to
Appendix B, "Hardware Specifications."
Note
Click Apply.
Step 4
Table 5-23
Port Type
(by CTC)
OC-48
STM-16
Repeat Steps
Step 5
Under Types, click the Alarm radio button and click Refresh.
Step 6
Step 7 Referring to
High, RX Power Low, TX Power High, and TX Power Low based on the client interface that is
provisioned.
Note
September 2005
DLP-G304 Provision the MXP_2.5G_10G and MXP_2.5G_10E Client Port Alarm and TCA Thresholds
This task provisions the client port alarm and TCA thresholds for the
MXP_2.5G_10G and MXP_2.5G_10E cards.
None
DLP-G278 Provision the Optical Line Rate, page 5-6
DLP-G46 Log into CTC, page 2-25
Required
Onsite or remote
Provisioning or higher
Table 5-23, provision the Port N (where N = 1 through 4) TCA thresholds for RX Power
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
MXP_2.5G_10G and MXP_2.5G_10E Card Client Interface TCA Thresholds
Pluggable Port Module
(SFP)
ONS-SE-2G-S1
15454-SFP-OC48-IR
ONS-SE-2G-S1
15454E-SFP-L.16.1
3 and 4 to provision each additional client port.
Table 5-24, provision the Port N (where N = 1 through 4) Alarm thresholds for RX Power
You must modify 15 Min and 1 Day independently. To do so, choose the appropriate radio button
and click Refresh.
TCA RX TCA RX
Power Low Power High
-18 -3
-18 0
-18 -3
-18 0
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
TCA TX TCA TX
Power Low Power High
-16 3
-11 6
-16 3
-11 6
5-43