Chapter 5
Provision Transponder and Muxponder Cards
Table 5-19
MXP_2.5G_10G and MXP_2.5G_10E Muxponder Card Trunk Settings (continued)
Parameter
Description
ALS Mode
Sets the ALS function mode. The DWDM
transmitter supports ALS according to ITU-T G.644
(06/99). ALS can be disabled or can be set for one of
three mode options.
AINS Soak
(OC-N and STM-N payloads only) Sets the
automatic in-service soak period.
Step 4
Click Apply.
Return to your originating procedure (NTP).
Step 5
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and
MXP_2.5G_10E Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, double-click the MXP_2.5G_10G or MXP_2.5G_10E card where you want to change the
Step 1
line threshold settings.
Click the Provisioning > Line Thresholds tabs.
Step 2
Modify any of the settings described in
Step 3
September 2005
DLP-G226 Change Line Thresholds Settings for MXP_2.5G_10G and MXP_2.5G_10E Cards
Options
•
•
•
•
•
•
This task changes the line threshold settings for MXP_2.5G_10G and
MXP_2.5G_10E muxponder cards.
None
DLP-G46 Log into CTC, page 2-25
As needed
Onsite or remote
Provisioning or higher
Table
5-18.
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
Disable (default): ALS is off; the laser is not
automatically shut down when traffic outages
(LOS) occur.
Auto Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
Manual Restart: ALS is on; the laser
automatically shuts down when traffic outages
(LOS) occur. However, the laser must be
manually restarted when conditions that caused
the outage are resolved.
Manual Restart for Test: Manually restarts the
laser for testing.
Duration of valid input signal, in hh.mm format,
after which the card becomes in service (IS)
automatically
0 to 48 hours, 15-minute increments
5-39